NOTICE! Please read the entire label closely before using!

Before applying P-M-P LUSTER FINISH to a surface that has never been coated before, scrub the surface with P-M-P PREPARATION - STRIPPER reduced up to ten times with water. Do not mix with other cleaners. For best results, use a green or burgundy scrub pad for badly oxidized fiberglass. Rinse with fresh (warm if possible) water and wipe dry with a clean towel.

Warning! Never use this product when washing or maintaining your fiberglass after coating the substrate with P-M-P LUSTER FINISH. Damage to the coating may occur. For best results, maintain the P-M-P LUSTER FINISH with P-M-P WASH-n-WAX.

Never use on varnished or automotive painted surfaces, any type of aluminum or leather.

When removing or stripping previously applied P-M-P LUSTER FINISH, apply P-M-P PREPARATION -STRIPPER undiluted or straight from the bottle to the surface to be stripped. A green scrub pad or 600 to 1000 grit wet-n- dry sand paper should be used in conjunction with the P-M-P PREPARATION - STRIPPER to remove all layers. Strip a small, remote spot first as a practice area.

P-M-P PREPARATION - STRIPPER will remove soap scum, mud, grease, mildew stains, grime, ink, wine and oil. Available in quart cylinder bottles.

Caution: Keep out of reach of children. Wear protective gloves, protective clothing and eye protection when using. Should material come in contact with eyes, rinse for 15 minutes in clean water and call a physician. For skin contact, wash with soap, water and vinegar. If swallowed, drink 3 glasses of milk or water, do not induce vomiting and call a physician. Never mix with other chemicals. Contains: Alkaline detergent, water, glycol esters, alkaline, and surfactants