Use P-M-P PREPARER - STRIPPER to thoroughly clean
the surface of oxidation, grease, oil, etc. Stains must be removed.
We recommend using P-M-P STAIN REMOVER. When
the surface is dry, make sure oxidation and residue are removed.
Note: If not removed, whatever remains on the surface will be
sealed in after applying
P-M-P LUSTER FINISH. If oxidation remains after
cleaning, scrub with 600 to 1000 grit wet-n-dry sandpaper. Last
step not applicable for white surfaces.
APPLICATION: Make sure surface is thoroughly dry. Apply
in an area that is as dust free as possible. If using outdoors,
be sure to apply on a calm day to eliminate dust and dirt contamination.
For best results, surface should be between 55 to 95 degrees Fahrenheit,
and not hot to touch. Coats may be applied in direct sunlight.
Pour a small amount of P-M-P LUSTER FINISH in
a shallow container, saturate one applicator completely and then
ring it out. Hold applicator flat to the surface and apply slowly
with long straight strokes.
P-M-P APPLICATORS are designed to yield a more
professional job. Avoid going over same area with an additional
application until the previous coat is dry. Do not worry about
slight streaking or disappearance during the first applications.
Drying time should be at least 1 to 4 minutes seconds between
coats. Not intended for use on automobiles or textured surfaces.
Check for desired results with a small test area. Each coat will
increase luster, therefore maximum appearance will require 4 to
5 coats. Allow completed application 24 hours for curing. Maintain
with mild detergent or P-M-P WASH-N-WAX.
P-M-P LUSTER FINISH provides excellent protection
for metals such as stainless steel, brass, bronze and chrome.
Rub rails, handrails and deck fittings may also be treated to
give long lasting protection.
P-M-P LUSTER FINISH improves the appearance
and protects aluminum boats, outboard motors, dock boxes, tackle
boxes, deck furniture, fishing tackle and other fiberglass products.Do
not allow product to freeze. Available in quart cylinder bottles.
Avoid sodium hydrozide based cleaners. Avoid ammonia based cleaners.
Keep out of reach of children
Should damage occur, POLIGLASS LUSTER FINISH
may be touched up and color differences will blend within a week.
|
